![]() ![]() ![]() Then, layer by layer, the print builds on top of that. Once your print is loaded into the 3D printer, the printer starts by heating up the tip of the extruder and laying down lines of filament that will become the raft. Filament Spindle: the place where the maker, or staff in this case, puts the spool of filament.Filament Drawer: the thing that slides out to allow filament to be loaded on to the filament spindle.Filament Guide Tube: a plastic tube that guides the end of the PLA filament to the extruder.Gantry: moves the extruder assembly where in needs to be to extrude.Don’t stick your finger under it, while printing. The Extruder Assembly: the extruder is the part of the printer that moves the filament to where it needs to be and heats it up before-you know-extruding it onto the build plate.The printer will usually start by laying down a raft on the build plate. Your model cannot have dimensions larger than the length and width of the build plate. The Build Plate: is where your print job starts, the ground floor of your print.To the right of the Control Panel is the port the thumb drive is inserted into. The Control Panel lets the maker select the file to be printed and gives information about the print job. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |